Beko Air Conditioners Error Codes List

Beko air conditioners are equipped with an innovative self-diagnosis system. According to its results, when a malfunction is detected, the control device blocks the operation, reporting simultaneously its cause. The equipment reports defects in operation by flashing LEDs that light in a certain sequence, showing the number of the detected malfunction.

Beko air conditioner error detection can be dealt with without involving a service technician. To do this, you just need to know how the information embedded in the program by the manufacturer is decrypted. It should also be remembered that the system displays the DTC with high priority.

The main causes of breakdowns

improper unprofessional installation of a split system, carried out independently or by incompetent masters;
non-compliance with the requirements for the operation of the unit;
ignoring scheduled maintenance;
normal wear of parts after prolonged use.

When does the Beko air conditioner turn off?

The equipment will shut itself off if:

Secondary activation of the compressor does not occur within 3 minutes.
If on top of the compressor the temperature exceeds 115 degrees. Normal operating temperature should not exceed 100 degrees.
If the mains voltage drops below 175 or rises above 260 volts.
If the inverter overheats due to the fact that a strong current or a higher voltage is applied to it.
If the wires are open anywhere.
If the fan operates more intensively than the norm or vice versa weaker (norm 300 - 400 rpm.).
If 4 minutes the system does not receive messages about crossing through zero.

After that, the self-diagnosis system starts searching for defects and malfunctions and, having detected them, displays the desired error code on the display.

Error codes for BEKO air conditioners BKC INV, BKL INV series

E1 - error of the internal temperature sensor
E2 - Evaporator Sensor Error
E3 - error in engine operation
E5 - switching error between indoor and outdoor unit
1E - error of the external temperature sensor
2E - capacitor sensor error

Error codes for air conditioners of the AKH, AKP, AS, BKH, BKP, BS series

F1 FF01 -
F3 FF03 - high condensing temperature in cooling mode
F4 FF04 - high condensation temperature in heating mode
F6 FF06 - incorrect operation of the fan motor of the indoor unit
F7 FF07 - error of the sensor of temperature of internal air
F8 FF08 - Evaporator Temperature Sensor Malfunction
F9 FF09 - condenser temperature sensor malfunction

Error codes for BKN and AKN air conditioners

Error	Indus RANNING	Indus SLEEPING	Indus TIMER
There are problems with the internal solenoid type temperature sensor	starts blinking	starts blinking	starts blinking
Diagnose a room temperature sensor defect	starts blinking	starts blinking	shines
There are problems with an external solenoid type temperature sensor	starts blinking	starts blinking	does not shine or blink
The fan motor in the indoor unit fails	starts blinking	shines	starts blinking